New MyNCT is a new product, it is not based on the the old myNCT written in Python. New myNCT is based on NCT104/FNC. 

Please do the following:


1. Install the latest system software (version 11 will be the best, but it is in prerelease state)
2. Enable myNCT in ESIS
3. Download end unzip this file 

http://www.nct.hu/pdf/NC_Documents/nc/MyNct.zip

4. Copy copy HTM folder and unrytags.ini to your Config folder (D:\ProgramData\NCT\Config)
5. Check macros O9400.nct-O9438.nct in your SystemMacros\Channel1  (D:\NCPrograms\SystemMacros\Channel1) folder. If they are not found there download the from http://www.nct.hu/pdf/NC_Documents/nc/SystemMacros_en.zip
6. Press Program\Edit button on the softkey. Check the state of "myNCT ON" button, it should be in pressed state.
7. Watch videos: 

for version 11:
https://www.youtube.com/watch?v=9-EbVQYwMp8

version 10:
https://www.youtube.com/watch?v=gj6Hgxgok-Y

8. We have a documentation for the milling macros in http://www.nct.hu/pdf/NC_Documents/nc/MyNct.zip 
(They are the same used in NCT104/FNC) (myNCTenglish.pdf)